Manufactered by :
CRC Industries Europe NV
Touwslagerstraat 1 – 9240 Zele – Belgium
Tel (32) (0) 52/45.60.11 Fax (32) (0) 52/45.00.34
TECHNICAL DATA SHEET
1/2
CRC ALU H.T.
Ref. : 10966
1. GENERAL DESCRIPTION
High temperature aluminium coating.
A high temperature paint based on silicone resins and active aluminium pigments.Alu H.T. is
designed to build a hard lasting finish that will not burn off, chip or peel at high temperatures.
2. FEATURES
· High thermal stability: resists temperatures up to 600°C.
· Excellent coverage.
· High durability.
· Quick drying at room temperature.
· Very good resistance to temperature fluctuations.
· Good weather stability. Although some loss of gloss can be noticed after extended exposure.
· Totally lead and chromate free.
· No chlorinated and no aromatic solvents.
· Aerosols use dimethylether (DME) propellant for controlled application and film properties.
3. APPLICATIONS
· Stove pipes
· Stoves
· Heaters
· Kilns
· Incinerators
· Chimneys
· Exhaust manifolds
· Headers
· Engines
· Ovens
· Steam pipes
4. DIRECTIONS
· Shake aerosol can very well for at least one minute after agitator ball is free. Stir or mix bulk
product well to
· obtain a homogeneous dispersion. Repeat frequently while using.
· Apply to a clean, degreased, dry surface for best results. Remove rust and scale with a wire
brush.
· Apply in light, even coats; best results are obtained with 2 lighter rather than 1 heavy coat.
Additional coats can be applied after 15-30 minutes.
· Complete curing occurs during use, typically after 1 h @ 200°C or 45 min. @ 250°C.
· When spraying is finished, clean aerosol valve by turning can upside down and pressing button
until only propellant escapes. If clogging occurs, remove button and clean orifice with fine wire.
· Do not use on energised equipment. Use in well ventilated area.
· A safety data sheet (MSDS) according EU directive 93/112 is available for all CRC products.
